1 800 665 7301 | info@tmetrix.com

Amplifier Research Model 150-100C, 150 Watt CW, 10 kHz – 100 MHz RF Power Amplifier

  • M1 through M5
  • 150 Watts CW
  • 10kHz–100MHz

 

REQUEST A QUOTE
SKU: Model 150A100C. Categories: , .

Description

The Model 150A100C amplifier is a selfcontained, broadband unit designed for laboratory applications where instantaneous bandwidth, high gain and moderate power output are required. Utilization of push-pull MOSFET circuitry lowers distortion, improves stability and allows operation into any load impedance without damage. The Model 150A100C, when used with an RF sweep generator, will provide a minimum of 150 watts of swept power.There is a digital display on the front panel to indicate the operate status and fault conditions when an over temperature, power supply, or amplifier fault has occurred. The unit can be returned to operate when the condition has been cleared. The 150A100C includes digital control for both local and remote control of the amplifier. This 8-bit RISC microprocessor controlled board provides both IEEE-488 (GPIB) and asynchronous, full duplex RS-232 control of all amplifier functions.Housed in a stylish, contemporary enclosure, the Model 150A100C provides readily available RF power for typical applications such as RF susceptibility testing, antenna and component testing, watt meter calibration, and use as a driver for higher power amplifiers. Amplifier Research Model 150 100C RF Power Amplifier

The export classification for this equipment is EAR99. These commodities, technology or software are controlled for export in accordance with the U.S. Export Administration Regulations. Diversion contrary to U.S. law is prohibited.

150A100C

Specifications

RATED POWER OUTPUT 150 watts
INPUT FOR RATED OUTPUT 1.0 milliwatt maximum
POWER OUTPUT @ 3dB COMPRESSION Nominal: 220 watts; Minimum: 180 watts
POWER OUPUT @ 1dB COMPRESSION Nominal: 155 watts; Minimum: 125 watts
FLATNESS 1.5 dB maximum
FREQUENCY RESPONSE 10 kHz – 100 MHz instantaneously
GAIN 52 dB minimum
GAIN ADJUSTMENT RANGE 18 dB minimum
INPUT IMPEDANCE 50 ohms, VSWR 1.5:1 maximum
OUTPUT IMPEDANCE 50 ohms, VSWR 2.0:1 maximum
MISMATCH TOLERANCE 100% of rated power without foldback. Will operate without damage
or oscillation with any magnitude and phase of source and load impedance. See Application Note #27.
MODULATION CAPABILITY Will faithfully reproduce AM, FM, or pulse modulation appearing on the input signal.
NOISE FIGURE (above 1.0 MHz) 6 dB typical
HARMONIC DISTORTION Minus 20 dBc maximum at 125 watts
THIRD ORDER INTERCEPT POINT 58 dBm typical
PRIMARY POWER 90–135/180-270 VAC auto ranging 47-63Hz, single-phase; 1000 watts maximum
REMOTE INTERFACES IEEE-488, RS-232.
CONNECTORS RF                             Type N female. See Model Configurations for location.
REMOTE CONTROL
IEEE-488                24 pin male
RS-232 9 pin Subminiature D (male)
REMOTE INTERLOCK 15 Pin Subminiature D
COOLING Forced air (self contained fans)
EXPORT CLASSIFICATION EAR99
Amplifier Research Model 150 100C RF Power Amplifier

Reviews

There are no reviews yet!

Be the first to write a review

*

Download Data Sheet