1 800 665 7301 | info@tmetrix.com

  • T3PS Series – Power Supplies by Teledyne Test Tools deliver precision, flexibility, and control in a compact form for both lab and industrial use.

    Key Features:

    • Programmable and non-programmable options with up to 4 independent outputs
    • Wide voltage and current ranges up to 60 V / 200 A / 1520 W
    • Multiple display types: TFT LCD, dual numeric, high-resolution panels
    • Output modes: Constant Voltage (CV), Constant Current (CC), Constant Resistance (CR)
    • Low ripple and fast transient response: ≤1 mVrms, ≤50 µs
    • Built-in series/parallel tracking, electronic load modes, and remote sense terminals
    • Interfaces: USB, LAN, RS-232, RS-485, Analog Control, Ext I/O
    • Advanced features: OVP, OCP, UVL, programmable slew rates, panel lock
    • Ideal for use in automotive, mobile, defense, research labs, and education
  • The Teledyne T3SA Series Spectrum Analyzers deliver high-performance signal analysis from 9 kHz to 3.2 GHz in a compact, easy-to-use design. Ideal for R&D, education, production, and pre-compliance testing, it features a large touchscreen and advanced digital IF technology.

    Key Features:

    • All Digital IF technology10.1”
    • WVGA (1024 x 600) touchscreen display
    • Frequency range from 9 kHz to 3.2 GHz
    • -161 dBm/Hz displayed average noise level (typical)
    • -98 dBc/Hz @ 10 kHz offset phase noise (typical)
    • Total amplitude accuracy < 0.7 dB
    • 1 Hz minimum resolution bandwidth (RBW)
    • Built-in preamplifier for improved sensitivity

    Typical Applications

    ● Research Laboratory
    ● Development Laboratory
    ● Repair and Maintenance
    ● Calibration Laboratory
    ● Automatic Production Test
    ● General bench-top use

    • Proven member of a modular Power Module family, more than 800 units are in service
    • Precision-regulated Bi-Polar output provides up to +12 to -12 Amps for Magnet loads.
    • Smooth operation through zero amps output current, no “Crossover” problems.
    • All 2510 MCOR12 Power Modules are identical and interchangeable.
    • Has two high-precision measurements of output current;
      • one is used to close the regulation control loop,
      • provides an independent monitoring signal to the Crate Interface Card.
    • Fault sensing circuitry in the module sets a Fault Latch which inhibits the output.
    • A (momentary) Sync input signal inhibits MOSFET switching when it is active (high);
      • this eliminate switching noise .
      • reduces power line noise during sensitive analog signal measurements.

     

    • Proven member of a modular Power Module family, more than 800 units are in service
    • Precision-regulated Bi-Polar output provides up to +30 to -30 Amps for Magnet loads.
    • Smooth operation through zero amps output current, no “Crossover” problems.
    • All 2510R30 MCOR30 Power Modules are identical and interchangeable
      • Programming Card is plugged into the replacement module.
    • Each channel has a critically-damped, LC noise filter with a cut-off frequency of about 8 kHz.
    • A 16-pin front panel diagnostics connector taps onto major circuit nodes which enables quick “inthe-crate” fault evaluation