1 800 665 7301 | info@tmetrix.com

BiRa Systems Inc.

BiRa has manufactured and supported well over a hundred D.O.E technology transfers from its National Laboratories; the system complexity ranges from VME High Voltage Systems at Fermilab to a Modular BiPolar power supply system (MCOR) at SLAC. The company’s products are designed to meet the needs of High Energy Physics facilities all around the world.

Showing all 6 results


    • Proven member of a modular Power Module family, more than 800 units are in service
    • Precision-regulated Bi-Polar output provides up to +12 to -12 Amps for Magnet loads.
    • Smooth operation through zero amps output current, no “Crossover” problems.
    • All 2510 MCOR12 Power Modules are identical and interchangeable.
    • Has two high-precision measurements of output current;
      • one is used to close the regulation control loop,
      • provides an independent monitoring signal to the Crate Interface Card.
    • Fault sensing circuitry in the module sets a Fault Latch which inhibits the output.
    • A (momentary) Sync input signal inhibits MOSFET switching when it is active (high);
      • this eliminate switching noise .
      • reduces power line noise during sensitive analog signal measurements.

     

    REQUEST A QUOTE
    • Proven member of a modular Power Module family, more than 800 units are in service
    • Precision-regulated Bi-Polar output provides up to +30 to -30 Amps for Magnet loads.
    • Smooth operation through zero amps output current, no “Crossover” problems.
    • All 2510R30 MCOR30 Power Modules are identical and interchangeable
      • Programming Card is plugged into the replacement module.
    • Each channel has a critically-damped, LC noise filter with a cut-off frequency of about 8 kHz.
    • A 16-pin front panel diagnostics connector taps onto major circuit nodes which enables quick “inthe-crate” fault evaluation

     

    REQUEST A QUOTE
    • 2U Chassis – 19″ rack mount 3.48” Height, 9.60” Depth and Weight 6lb.
    • Power 120V AC 60Hz
    • Washable front removable air filter
    • Ball Bearing AC fans provide 330 CFM
    • Dual plenum design
    • Cooling for 160mm,220mm depth modules
    • Diverts lower warmed air to rear of Cabinet
    • RM option diverts lower air to front of Cabinet

     

    REQUEST A QUOTE
    • accommodate these control schemes
    • total control system interface on a single VME-standard card
    • occupies the left-most slot of the crate
    • monitoring voltage reference inputs, output voltages and fault conditions
    • standard VMEbus-compatible 6U by 220 mm board installed
    • Eurocard crate
    • Two 96-pin I/O connectors

     

    REQUEST A QUOTE
  • MCOR Modules

    MCOR 2/6/9/12

    Each module can be customized to provide maximum outputs of 2 amps, 6 amps, 9 amps, and 12 amps. Up to 16 of these can fit in a single 6U VME style crate.

    MCOR 30

    Each module can provide a maximum output 30 amps. Up to 8 of these can fit in a single 6U VME style crate.

    REQUEST A QUOTE
    • provides precision bi-polar output currents
    • minimal zero-cross over distortion
    • 19” rack mounted 6U x 220 mm crate
    • crate has 17 slots; 16 (slot 0 thru 15)
    • connectors
      • J1 (ExtIntlk),
      • J2 (CrateOK),
      • J3 (Input Reference Voltages),
      • J4 (Output Monitors), and
      • J9 (Bitbus)

     

    REQUEST A QUOTE

Showing all 6 results

Contact ACA TMetrix Inc.

Address

3585 Laird Road, Unit 15 & 16, Mississauga ON L5L 5Z8

Phone: 1-800-665-7301

Fax: 1-905-890-1959

Email: info@tmetrix.com

About ACA TMetrix Inc.

ACA TMetrix Inc. is a leading supplier of test instruments and design tools in Canada. For over 50 years we have provided services and support for products that are manufactured by the world's leading instrument suppliers.

TMetrix Ltd. is Part of the ACA Group of Companies. Allan Crawford Associates (ACA), is one of Canada's largest distributors of electronic components, test equipment, and scientific solutions.

Our Location

Top